Rockwell Automation SF3000 Parallel Gate Amplifier System - Manual (Page 27)

Installation Guidelines 5-1
C
HAPTER
5
Installation Guidelines
This section provides guidelines for installing and replacing the PGA rack, the
modules, and the cable assemblies. This section provides general guidelines only.
Always refer to the wiring diagrams supplied with your system for specific installation
information.
5.1 Wiring the PGA Rack
The user must ensure that the installation of wiring conforms to all applicable codes.
To reduce the possibility of noise interfering with the control system, exercise care
when installing wiring from the system to external devices. For detailed
recommendations, refer to IEEE Standard 518.
!
ATTENTION:Only qualified personnel familiar with the construction and
operation of this equipment and the hazards involved should install,
adjust, operate, or service this equipment. Read and understand this
manual and other applicable manuals in their entirety before proceeding.
ATTENTION:The modules in the Parallel Gate Amplifier rack contain
static-sensitive components. Do not touch the module’s circuit board or
the connectors on the back of the module. When not in the rack, the
module should be stored in an anti-static bag.
!
ATTENTION: The user is responsible for conforming with all applicable
local, national, and international codes.