Rockwell Automation MD60 User Manual Version 3.0 - Manual (Page 103)

Parameters Cross-Referenced by Name C-3
Preset Frequency 1 A071 Advanced 0.0 Hz 9-13
Process Display d010 Display Read Only 9-29
Process Factor A099 Advanced 30.0 9-21
Process Time Lo A115 Advanced 0.00 9-26
Process Time Hi A116 Advanced 0.00 9-26
Program Lock A101 Advanced 0 = Unlocked 9-21
PWM Frequency A091 Advanced 4.0 kHz 9-18
Relay Output Level A056 Advanced 0.0 9-11
Relay Output Select A055 Advanced 0 = Ready (Not
Faulted) 9-9
Reset to Defaults P041 Basic 0 = Idle State 9-7
Reverse Disable A095 Advanced 0 = Reverse
Enabled 9-19
S Curve% A083 Advanced 0% (Disabled) 9-15
Slip Compensation A114 Advanced 2.0 Hz 9-25
Speed Reference P038 Basic 0 = Drive
Potentiometer 9-6
Start At Power Up A094 Advanced 0 = Disabled 9-19
Start Boost A084 Advanced 8 = 5.0 9-16
Start Source P036 Basic 0 = Keypad 9-3
Stop Mode P037 Basic 1 = Coast,
Clear Fault 9-5
SW Current Trip A098 Advanced 0.0 (Disabled) 9-21
Testpoint Data d019 Display Read Only 9-32
Testpoint Select A102 Advanced 0000 9-22
Parameter Name No.
Parameter
Group
Default
Value
Page
No.