Rockwell Automation SCD Operating Software - Manual (Page 2)

Important
User Information Because of the variety of uses for the products described in this publication, those
responsible for the application and use of this control equipment must satisfy
themselves that all necessary steps have been taken to assure that each application
and use meets all performance and safety requirements, including any applicable
laws, regulations, codes and standards.
The illustrations, charts, sample programs and layout examples shown in this
guide are intended solely for purposes of example. Since there are many variables
and requirements associated with any particular installation, Rockwell Automation
Allen-Bradley does not assume responsibility or liability, including intellectual
property liability for actual use based upon the examples shown in this
publication.
Related Safety Information
You are responsible for the safety of the entire installed control system and for
meeting all applicable laws, codes, and safety requirements.
ATTENTION: As the installer of this control system, you
must be knowledgeable of other applicable standards pertaining
to safety recommendations related to:
• Machine Construction
• General Electrical
• Machine Guarding
• Point of Operation guards, safety light curtains, mechanical
guards, and Two hand controls
In addition to local laws and codes, you are responsible for the
safety recommendations detailed in all applicable codes and
standards including:
• OSHA Regulations
• ANSI Standards
• NFPA
• CSA
IMPORTANT Rockwell Automation reserves the right to make revisions
to these installation instructions and disclaims liability for all
incidental and consequential damages related to the
furnishing, performance and use of this material.