Rockwell Automation T8310 Trusted Expander Processor - Manual (Page 10)

Trusted
TM
Module T8310
Issue 12 Dec 06 PD-T8310 10
2. Installation
The Expander Processor module always resides in one of the two processor (left most - PL1 and PL2)
slots within the Expander Chassis. The Expander Processor must NOT be installed in these other
module locations, as this may cause damage to the module.
Figure 2 Expander Processor Slots
The two processor slots must be interconnected using the Cable Hood Assembly shown below.
Figure 3 Expander Processor Cable
The Expander Processor Modules are connected to the Expander Interface modules by the Expander
Interface Hot Link Cable TC-301 via the Trusted
TM Expander Interface Adaptor Unit T8312.
Remote Expander Processor Modules are connected to the Trusted TM Fibre Optic Tx/Rx Unit T8314 by
the Fibre Tx/Rx Unit to Expander Processor (Remote Expanders) Cable TC-303.
The connection to the Trusted TM Fibre Optic Tx/Rx Unit from the Expander Interface Modules is via the
Trusted TM Expander Interface Adaptor Unit using the Expander Interface Adaptor to Fibre Tx/Rx Unit
(Remote Expanders) Cable TC-302.