AJA IoXT - Manual (Page 38)

Io XT v10.4 www.aja.com 38
HDMI Screen
The Io XT’s HDMI input and output are shown and configured at this screen.
Figure 32. AJA Io XT HDMI, HDMI Screen
HDMI Output Settings The Source pulldown menu allows you to select either the primary video format
(framebuffer) or a secondary one (up/down/cross-conversion).
Pulldowns are also provided for configuring the video output range, color space and
number of embedded audio channels (2 or 8) for the HDMI output. A Protocol pulldown
allows you to choose either “HDMI” or “DVI” protocol—use DVI if you’re outputting to a
DVI monitor using an HDMI to DVI adapter.
A pulldown menu for 3D output allows you to select either Side-by-Side or Top-Bottom
(Stacked) output of left-eye and right-eye signals.
NOTE: This selection must agree with format selection in the third-party CineForm Codec (NOT
included with AJA Io XT) pulldown menu.
Audio Channels: An Audio Channel pulldown allows you to select the number of embedded audio
channels for the HDMI output.
HDMI Input Settings The detected HDMI input video format is displayed and you’re given a chance to
configure the RGB range (SMPTE or FULL) and select any two embedded channel pairs
from those supplied for stereo output (if applicable).