Autocue QMaster Complex - Manual (Page 9)

QMaster Comple Language-UserGuide.docx 2012-10-02
9
© 2003-2011 Autocue Group Ltd.
Note: It is recommended that the licence dongle is always inserted into the same USB port.
Depending on the hardware and software configuration of your computer, it may be
necessary to re-install the Sentinel drivers for each USB port.
When you start QMaster for the first time you will be prompted to configure the connection to your QBox. A
connection wizard will guide you through this process.
1. The dialog box below will be displayed. Press Next if you wish to configure the
connection.
1. Enter the name of your QBox.
The default value is the QBox hostname based on the serial number of the device you
have.
Note: The serial number is shown on the printed label attached to the bottom of your QBox.
2. Enter the IP address of your QBox.
The IP address will be the value you assigned in the previous procedure.
3. The default Port number is recommended but you can change this to an alternative one if
your network requires it.
4. Press Next to display a summary of the information entered.