Baumfolder BAUM20: Control Panel - Manual (Page 3)

TP10386 © Page 3 of 12
.
Then Press the GREEN Button to lower Pile Feed Table. The
Table will lower and stop automatically in its lowest position.
STARTING PRODUCTION WITH THE BAUM 2020
1. To START the Folder Drive, Press the GREEN Button on the Control
Panel
just ABOVE the symbol, this will Start the Folder Drive and the
Pump will automatically come on.
2. To STOP the Folder Drive, Press the RED Button on the Control Panel
just BELOW the symbol or Press the RED EMERGENCY STOP
Button on the Control Panel or on the Stacker Control Panel. The Folder
Drive will STOP , The Pump may continue to run for about 7 seconds. If
you want to stop the pump at the same time as the folder drive press the
Drive STOP button twice within a 0.5 seconds.
The Pump circuit has a minimum ON time of 4 SECONDS. If the Pump is
commanded OFF within 4 seconds after it is started, it will continue run for
the duration of the 4 seconds and then shut OFF.
3. To Turn the Pump ON without the Folder Drive coming On, Press the
GREEN Button ABOVE the symbol
4. To Turn the Pump OFF, Press the RED Button BELOW the
symbol NOTE: the Pump will stay ON for at least 4 SECONDS before
being able to shut off.
Easy Mode:
This mode is an automatic setup mode that sets the sheet gap to 1 inch and
vacuum duration to 5 inches. Most jobs may be ran with this mode of operation.
A Z-fold or a product with a window will require the Continuous Mode of
operation.
You can not change the sheet gap or vacuum duration settings
manually using the Easy-Mode. Only the DCT500 mode or Continuous Cycle
mode allows adjustment of these settings.