Baumfolder BAUM20: Control Panel - Manual (Page 6)

TP10386 © Page 6 of 12
SELECT CONTINUOUS CYCLE MODE
It is recommended to use the continuous cycle mode when the job requires more
than ½ of the sheet length to go in the #1 fold plate or if the product has a
window that will be sensed as the trailing edge of the sheet.
The continuous cycle mode allows you to select the SHEET GAP, SHEET
LENGTH and the SUCTION LENGTH.
Pressing this button enables the selection of either the EASY mode or cYcL
mode
Pressing these buttons will toggle between the EASY mode or cYcL mode. Set
cYcL in the large display (see figuree E1).
SETTING THE SHEET GAP AND SHEET LENGTH
The small 3 digit display shows the current setting for the sheet gap. The
number on the right hand side of the large display (1) represents the current
sheet length. Set the sheet gap and sheet length for the current job.
SETTING THE SUCTION LENGTH
Use the + and – buttons under the 10 segment bar graph display to adjust the
suction length. Each segment represents 5% of sheet length. If 10 segments
are illuminated 50% of sheet length is selected. So, it is important that the sheet
length is set properly for the current job.
Press the mode selection button again to exit mode selection.
+
+