Baumfolder Gatefold - Manual (Page 3)

1. Install mounting post to feeder
frame on the non-operator side of
the folder. Drill (2) ¼ inch or 6.5mm
diameter clearance holes in the
frame as shown. Use the hardware
kit supplied to mount the post to the
frame
.
2. Place the control unit on top of
the mounting post. Install the power
cord. Connect the Optical sheet sensor
to Input 1. Connect the electrical cord
from the gatefold plate to Output 1.
Connect the encoder cable to the
Encoder connection. View shown is
from the backside.
3. Disconnect power from folder.
Wire the other end of the Encoder
cable to the main electrical box on the
folder. Insert encoder cable through
an opening available in the back of
the main control box of the folder.
Go to connector block 2X15. Connect
the gatefold encoder cable wire #1 to
pin #1 with the white wire.
Connect gatefold encoder cable wire
#2 to pin #2 with green #2 wire.
3