Baumfolder Gatefold - Manual (Page 8)

4. Reinstall foldplate #2 and have it set to deflect the paper. Leave #4 position
open without a foldplate. Set foldplate #3 open to folding to make the second
foldlength (L2). On an 11x17 sheet this length will be approximately 8-1/2
inches. Send test sheets and match against sample until fold is satisfactory.
5. Install the gatefold plate in the #4
position. Do not connect the power
supply to the gatefold. Pull the
movable sheet-tucking device down
away from the fold rollers to allow the
sheet to enter the plate in the
deactivated mode. Set the analog
readout device for fold depth to
approximately 105mm for an 11x17
gatefold. For other lengths, measure
the sample and set accordingly. Run
test sheets until the proper fold length
is achieved. The test sheets will exit
onto the delivery stacker with the last flap trailing the sheet. Pick up the sheet
and fold the flap in to test the length setting.
6. Install the Optical position sensor
under the #3 foldplate. This may
already be installed from previous
setup. Make sure that the sensor is
located down as far as it can be set
closest to the fold rollers.
7. Set up the Gatefold Control settings. You must set
the L1, L2 and the position sensor settings to run the
job.
8