Baumfolder BaumCut 31.5 (For serials 76N1101 thru 78N1000) - Manual (Page 52)

K5A - 18
1 2 3
4 5 6
7 8 9
C 0
x
D
i
PROG PROGRAMMABLE
5.0 Automatic Operation
Automatic ON/OFF
Funtion: Automatic backgauge advance to the next step number
after cutting process
Automatic ON:
Press key < after cut: automatic backgauge advance to next cut size;
display reads: AUTOMATIC
Automatic OFF:
Press key
Attention!
When Automatic is switched on the following operations are not possible:
• programming
• automatic setting of backgauge through size input
Positioning check in automatic operation
For example, when a positioning process in automatic operation has been inter-
rupted (cutting position has not been reached!) and the operator tries to release a
cut in automatic mode after that, a visual and audible indication is made "GO TO
POSITION".
When the position must be moved to:
Press key twice