Baumfolder Flexifold: Turbo Wheel Upgrade Kit Installation - Manual (Page 4)

11) Re-install the vacuum adapter
12) Secure plate for vacuum adapter
using the (4) soc hd cap screws
removed in step #7.
Make sure the feed wheel spins freely
and that the lip of the vacuum adapter
is mated up against the feed wheel.
13) Place the Feed Wheel Assembly
back flat on table.
14) Position the Feed Table over the
Feed Wheel assembly and line up the
(6) mounting holes.
Re-install the (6)
4mm flat head screws
removed in step #5 and once all have
been started tighten them using a 2.5
mm hex key.
15) Slide the Blow Tube back into
mounting bracket