Baumfolder Flexifold: Turbo Wheel Upgrade Kit Installation - Manual (Page 5)

16) Align the scribe marks on the
blow tube and tighten the set screw
locking the blow tube into position.
17) Sight down the front edge of the
orange sheet detector tab to make sure
it is even with the edge of the vacuum
manifold.
18) If the sheet detector tab is not in
proper alignment loosen the (4)
screws holding the rack adapted plate
in place ( two on each side) and move
the front gear rack forward or
backwards to line up the orange tab.
When you have finished aligning the
tab re-tighten the screws.
19) Re-install the feed table back into
your folder and reconnect the air and
vacuum hoses.
You are now ready to run paper through your up dated Baum 714XLT or
Baum Flexifold.
Due to the superior performance of the new Turbo Suction wheel you will want to
reduce the amount of vacuum or you may start pulling doubles.