Baumfolder BAUM1620 Gapset Calibration User Manual
Page 10
10
b) After feeling the pressure on the strip of paper on the operator side, gently pull
on
the
strip
of
paper
on
the
non-‐operator
side
and
feel
the
amount
of
pressure
the
fold
rolls
are
applying.
o If pulling on this strip of paper fells like there is not enough pressure and does
not
cause
the
fold
rolls
to
start
rotating,
turn
the
gapset
knob
counter-‐clock
wise
to
add
more
fold
roll
pressure.
o If pulling on this strip of paper fells like there is too much pressure and cause
the
strip
of
paper
to
tear
rotating,
turn
the
gapset
knob
clock
wise
to
reduce
the
amount
of
fold
roll
pressure.
c) Now that you have initially cailbrated the fold roll pressures on the operator and
non-‐operator
sides,
you
must
go
back
and
check
the
pressures
on
each
strip
of
paper
again
to
ensure
the
pressures
remained
the
same.
You
may
have
to
readjust
the
pressure
on
each
side
to
ensure
the
proper
amount
of
fold
roll
pressure
is
maintained.
During
calibration
of
the
fold
roll
pressure
settings,
it
is
critical
to
ensure
that
the
amount
of
drag
on
both
the
operator
and
non-‐operator
sides
is
the
same!
d) Repeat steps 3 & 4 by adjust the proper gapset knobs for:
#2
fold
roll
to
main
fold
roll(strips
of
paper
in
between
the
#2
and
main
fold
rolls
&
adjusting
the
#2
gapset
knobs),
then
#3
fold
roll
to
#2
fold
roll(strips
of
paper
in
between
the
#3
and
#2
fold
rolls
&
adjusting
the
#3
gapset
knobs),
then
#4
fold
roll
to
#3
fold
roll(strips
of
paper
in
between
the
#4
and
#3
fold
rolls
&
adjusting
the
#4
gapset
knobs),
then
#5
fold
roll
to
#4
fold
roll(strips
of
paper
in
between
the
#5
and
#4
fold
rolls
&
adjusting
the
#5
gapset
knobs.
5. Now that all of the fold roll pressures have been calibrated properly, while holding each gapset
knob
so
that
it
does
not
move(if
the
gapset
knob
turns,
the
fold
roll
pressures
will
change),
turn
each
gapset
indicator
dial
so
that
each
dial
is
set
at
1.