Bendix Commercial Vehicle Systems VORAD VS-400 INSTALLATION NOTES - Manual (Page 26)

General Information
24
Diagnostic Trouble Code (DTC)
Isolation Procedures
Component Code: 25
(SA 42, SPN 898, FMI 13, 14)
SmartCruise ® Adaptive Cruise Control Configuration Error
Overview
This code indicates that the VS-400 Forward Looking Radar (FLR) has detected a SmartCruise configuration or compatibility issue with the
engine .
Diagnostic Trouble Code (DTC) Detection
At power up, the FLR attempts to verify if the engine controller is SmartCruise ® adaptive cruise control compatible and has its Adaptive
Cruise Control (ACC) setting(s) enabled . If the FLR determines that one of these conditions is false, this Diagnostic Trouble Code (DTC) is
set .
• Code 25, FMI 13 - Engine is not configured for SmartCruise ® adaptive cruise control .
• Code 25, FMI 14 - Engine ID is not recognized as SmartCruise ® adaptive cruise control compatible .
Symptom
When this code is active, the Bendix ™ VORAD ® VS-400 Collision Warning will continue to operate, but the Bendix ™ SmartCruise ® adaptive
cruise control will not . The DIU will indicate SmartCruise ® adaptive cruise control is not operational and the orange DTC light will be
illuminated .
Possible Causes
• FMI 13 - The engine controller setting for Adaptive Cruise Control is not enabled.
• FMI 14 - The engine does not support the Adaptive Cruise Control function or is not compatible with the VS-400 system.