Overview, Diagnostic trouble code (dtc) detection, Symptom – Bendix Commercial Vehicle Systems VORAD VS-400 INSTALLATION NOTES User Manual

Page 34: Possible causes, Repair procedure

Advertising
background image

General Information

32

Diagnostic Trouble Code (DTC)

Isolation Procedures

Component Code: 92

(SA 42, SPN 886, FMI 14)

Forward Looking Radar Not Detecting Objects or Radar Blocked

Overview

This code indicates that the Forward Looking Radar (FLR) has not detected a target in an excessive amount of time or has become
blocked .

Diagnostic Trouble Code (DTC) Detection

When the FLR has gone a period of time without receiving any reflected radar signals this Diagnostic Trouble Code (DTC) is set . This
may simply indicate that the vehicle has been in an extremely desolate area without any vehicles or objects to reflect its radar signals .
Non-vehicular objects such as road signs, highway overpasses and background trees should provide enough radar signals to prevent this
Diagnostic Trouble Code (DTC) from being set . This Diagnostic Trouble Code (DTC) may also indicate that the FLR has become blocked by
mud, snow, ice, or other debris .

Symptom

The Bendix

VORAD

®

VS-400 Collision Warning System and the Bendix

SmartCruise

®

adaptive cruise control will fail to operate, however,

the driver will have access to conventional cruise control . The Driver Interface Unit (DIU) will illuminate an orange DTC light and display a
message indicating the Diagnostic Trouble Code (DTC) condition . If the VS-400 system once again begins to detect objects, the condition
will clear and the system will resume normal operation .

Possible Causes

Obstructed Radar View

Correct Operation, but with a lengthy time since the last radar object was detected

Repair Procedure

Active Diagnostic Trouble Code (DTC)

Steps to Perform

Code 92, FMI 14

1 .

Check the Forward Looking Radar for debris buildup (snow, mud, etc .) or if the radar's
view is being obstructed .
Note: This Diagnostic Trouble Code (DTC) is automatically set inactive after each
power cycle .

2 .

Road test vehicle and make sure the Diagnostic Trouble Code (DTC) condition has
cleared .

3 .

Test Complete .

Advertising