Bendix Commercial Vehicle Systems VORAD VS-400 INSTALLATION NOTES User Manual
Page 44
General Information
42
Appendix 3 continued
Positive Azimuth Adjustment (FLR too far to the Right)
If the alignment function shows a negative value, then the FLR is adjusted too far to the right, when looked at from the driver's seat . The
radar needs to be adjusted to the driver's left . To accommodate this, adjust the horizontal alignment screw, by turning it in a counter-
clockwise direction, when viewed from the front of the vehicle. Each full rotation of the alignment screw adjusts for approximately 0.2° of
azimuth position from the alignment function. For example, if the azimuth position was -0.5°, then the alignment screw should be adjusted
2
1
/
2
turns counter-clockwise .
After adjustment of the FLR, perform the calibration procedure again to verify proper alignment .