Brandmotion 9002-7607 User Manual

Installation instructions

Advertising
background image

 

INSTALLATION  INSTRUCTIONS  

 

7607 Chevrolet Express-GMC Savana Instructions 2-20-13.doc Page 1 of 2

Chevrolet Express/GMC Savana Camera Installation Instructions, 2008 – current

(Kit # 9002-7607)

Please read thoroughly before starting installation and check that kit contents are complete.

Items Included in Kit:

CHMSL Mount Camera and Harness
Video Harness
Chassis Harness
Power Harness
Jumper Harness
Female to Male RCA Adaptor (not shown at right)
These Instructions

Tools & Supplies Needed:

Multi-meter or computer-safe test light
Plastic Trim Removal Tool
Electrical Tape or Heat Shrink Tubing
Soldering Iron (recommended)
Solder (recommended) or T-Taps
Wire Ties (recommended)
Ground Eyelet (recommended)

Safety Precautions:

•

Work in a well ventilated area that is clear of obstructions.

•

Secure vehicle with tire chucks in both front and rear of tires.

•

Turn vehicle accessories OFF and ensure ignition key is in OFF position.

•

Wear safety goggles and snug fitting clothes.

•

Use tools only for their intended purpose and which are in good repair.

•

Only perform this task if confidence, skill, and physical ability permit.

NOTE: We strive to provide accurate and up-to-date installation instructions. The latest full color

instructions can be accessed at www.brandmotion.com

Step 1: Use a Phillips screwdriver to remove two
screws retaining the Center High-Mount Stop Lamp or
CHMSL
(commonly known as the Third Brake Light.) Save
screws to attach Camera.

Step 2: Disconnect the brake lamp socket from the
CHMSL and remove the CHMSL.

Step 3: Cut the rubber CHMSL harness grommet (shown
as part #4 at Step 2) at its base and remove.

Step 4: Thread Camera Harness video and jumper
connector ends through the grommet and through the
CHMSL opening.
Recommended: Apply a dab of silicone to
retain grommet in place and maintain a water tight seal.

4 4

Advertising