Brandmotion 9002-7608 User Manual

Installation instructions

Advertising
background image

 

INSTALLATION  INSTRUCTIONS  

 

7608 Nissan NV Instructions 4-1-13.doc

Page 1 of 2

Nissan NV Camera Installation Instructions, 2012 – current (Kit # 9002-7608)

Please read thoroughly before starting installation and check that kit contents are complete.

Items Included in Kit:

CHMSL Mount Camera and Harness
Video Harness
Chassis Harness
Power Harness
Jumper Harness
Female to Male RCA Adapter (not shown at right)
These Instructions

Tools & Supplies Needed:

Multi-meter or computer-safe test light
Plastic Trim Removal Tool
Electrical Tape or Heat Shrink Tubing
Soldering Iron (recommended)
Solder (recommended) or T-Taps
Wire Ties (recommended)
Ground Eyelet (recommended)

Safety Precautions:

•

Work in a well ventilated area that is clear of obstructions.

•

Secure vehicle with tire chucks in both front and rear of tires.

•

Turn vehicle accessories OFF and ensure ignition key is in OFF position.

•

Wear safety goggles and snug fitting clothes.

•

Use tools only for their intended purpose and which are in good repair.

•

Only perform this task if confidence, skill, and physical ability permit.

NOTE: We strive to provide accurate and up-to-date installation instructions. The latest full color

instructions can be accessed at www.brandmotion.com


Step 1: Use a Phillips screwdriver to remove two
screws retaining the Center High-Mount Stop Lamp or
CHMSL
(commonly known as the Third Brake Light.) Save
screws to attach Camera.

Step 2: Disconnect the brake lamp socket from the
CHMSL and remove the CHMSL.

Step 3: Camera Harness video and jumper connector

ends through the CHMSL opening.
Step 4:
Connect Camera Harness jumper connector to

supplied Jumper Harness.

Step 5: Connect red wire of Jumper Harness to light
green CHMSL brake lamp wire (12v+ power) and black
wire to chassis ground
(Recommended: Solder or T-Taps).

Wire

Color Polarity

Function

Description

Location

Red

12v +

CHMSL

illumination

Displays 12 volts +
with brakes applied

CHMSL

light green

wire

Black

(–)

Ground

Brake light ground

CHMSL

black wire

Step 6: Attach supplied Camera using existing screws.

CAUTION: Do not over tighten.
Step 7: Connect Camera Harness video connector to

supplied Chassis Harness.

Advertising