Brandmotion 9002-8836 User Manual
Installation instructions
INSTALLATION INSTRUCTIONS
8836 Instructions 10-7-14.docx
Page 1 of 7
Jeep Wrangler Rear Vision System with Mirror Display, 2007-Current
(Kit # 9002-8836)
Items Included in the Kit
Camera
Chassis Harness
Mirror Harness
Mirror with video display
Zip lock bag with 15 Wire Ties & 3 Push Nuts
These Instructions
Required Tools & Supplies
T15 & T20 Torx Bits
7mm & 10mm Sockets
Phillips Screwdriver
Plastic Trim Removal Tool
Soldering Iron, Solder, & Heat Shrink Tubing
(RECOMMENDED) or T-taps as an alternate
splicing method
Electrical Tape
Install Camera
Step 1: Loosen lug nuts to remove spare tire.
Step 2: Slide Camera on studs placing harness end
inside of tire carrier.
Step 3: Temporarily replace spare tire to check wheel
clearance to Camera.
Wheel Alignment for Camera Clearance
Step 4: Remove spare tire and slide (3) supplied Push
Nuts on the studs.