Brandmotion 9002-8836 - Manual (Page 6)

INSTALLATION
INSTRUCTIONS
8836 Instructions 10-7-14.docx Page 6 of 7
Step 35: Remove 7mm bolt.
Step 36: Remove driver knee bolster cover.
Step 37: Remove (2) 7mm bolts on both sides of the
steering column.
Step 38: Remove center stack/cluster surround.
Step 39: Remove glove box for access and run Mirror
Harness toward center of dash.
Step 40: Using a plastic trim removal tool, remove
HVAC panel.
Step 41: Run Red 12v+ ignition wire of supplied Mirror
Harness to ignition controlled power point on HVAC
panel power point.
Step 42: Splice Red power wire to Blue/Red wire on
back of power point. RECOMMENDED: Use solder and
cover with heat shrink tubing or use T-taps as an
alternate connection method.