Brandmotion 9002-7605 User Manual

Brandmotion For the car

Advertising
background image

2010-Current Ford Transit Connect Aftermarket CMOS Camera with Optional Parking

Gridlines Installation Instructions (Kit # 9002-7605)

7605 Ford Transit Connect Instructions 10-11-12.doc

Page 1 of 3

Please read thoroughly before starting installation and check that kit contents are complete.

Items Included in Kit:

Tools & Supplies Needed:

Chassis Harness

Multi-meter or computer-safe test light

Power Harness with RCA connectors

Ground Eyelet (recommended)

Camera mounted in license plate lamp cover

Soldering Iron

Instructions

Wire Ties or Electrical Tape

Solder (recommended) or T-Taps

Plastic Trim Removal Tool

Safety Precautions:

•

Work in well ventilated area that is clear of obstructions.

•

Secure vehicle with tire chucks in both front and rear of tires.

•

Turn vehicle accessories OFF and ensure ignition key is in OFF position.

•

Wear safety goggles and snug fitting clothes.

•

Use tools only for their intended purpose and which are in good repair.

•

Only perform this task if confidence, skill, and physical ability permit.

NOTE: We strive to provide accurate and up-to-date installation instructions. The latest full color

instructions can be accessed at www.brandmotion.com

Step 1: Use a plastic trim removal tool to extract
pins from rear door inner trim panel and remove.

Step 2: Unplug right license plate lamp connector.

Step 3: Remove license plate lamp and separate
bezel from cover.

Step 4: Thread connector end of the camera
harness through license plate lamp bezel. Snap
supplied camera on license plate lamp bezel.

Advertising