Brandmotion 9002-8836 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
8836 Instructions 10-7-14.docx Page 3 of 7
Step 13: Pull out subwoofer box slightly to gain access
to run Chassis Harness along existing harness
Step 14: Pull back carpet and continue running Chassis
Harness forward.
Step 15: Run Chassis Harness under B-pillar cover to
passenger door sill. Use a plastic trim removal tool to
remove the (2) plastic push pins and remove passenger
sill plate/kick panel.
Step 16: Use a 10mm socket to remove the existing nut
located behind the passenger kick panel and attach
ground eyelet of Chassis Harness to chassis ground.
Install Mirror
Step 17: Unplug factory mirror connector from back of
mirror.
Step 18: Use a T15 Torx bit to remove factory mirror
and slide the mirror upward off the mounting tab.
CAUTION: Do not twist mirror as windshield damage
could result.
Step 19: Carefully install supplied Mirror by sliding it
downward on the mounting tab. CAUTION: Torque
supplied Mirror screw to 1.8 Nm (16 lb-in) and do not
exceed 2.2 Nm (19.5 lb-in).