Rfi cold air intake – Bully Dog 53108 Rapid Flow Induction (RFI) Cold Air Intake User Manual
Page 6
Advertising
9
10
RFI COLD AIR INTAKE
RFI COLD AIR INTAKE
2. Use the T20 Torx bit to remove the MAF sensor from the
OEM intake tube.
3. Swap the OEM MAF O-ring for the Bully Dog O-ring.
4. Attach the MAF sensor to the Bully Dog intake tube. Use the
nylon washers and the black oxide Phillips screws provided
by Bully Dog. Use two washers on each side.
5. Use the T20 Torx bit to remove the temperature sensor from
the OEM box.
6. Attach temperature sensor to the Bully Dog Stage 2 intake
tube. Use the nylon washers and the black oxide Phillip
screws provided by Bully Dog. Use one washer on each
side.
IMPORTANT: Do not overtighten the screws, as
this could damage the MAF sensor.
Advertising