Bully Dog 53108 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 7)

11 12
RFI COLD AIR INTAKE RFI COLD AIR INTAKE
Installing the RFI Intake
1. Mount the RFI Enclosure Base in the space made by
removing the stock intake. Use the three provided M6 flange
bolts. Failure to use the bolts provided by Bully Dog could
result in damage to the RFI.
2. Connect the stage 2 air intake tube to the Bully Dog air intake
tube (with MAF mount) and the turbo inlet tube in the engine
bay. Leave the band clamps loose until you are sure that all
of the connections are properly aligned, and then tighten the
clamps with a flat-head screwdriver.
7. Connect the silicone couplers to the stage 2 air intake tube.
Do not tighten the band clamps. Leave them loose so you
can adjust the couplers into the correct position.