Bully Dog 81410 Rapid Flow - Manual (Page 5)

4
4
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81410
REMOVAL OF STOCk EXHAUST SySTEM
1. Use a sawzall to cut the exhaust immediately behind
the muffler.
2. Cut the exhaust using a sawzall 4” behind the catalytic
converter.
3. Unbolt the flange at the front of the catalytic convert-
er and remove the catalytic converter for installation
later.
4. Cut the exhaust at the bottom of the down pipe.
5. Cut the flange off of the turbo down pipe. This is re-
quired in order to remove the stock down pipe. Re-
move the stock down pipe by removing it from under-
neath the vehicle.
6. Loosen the stock band clamp that is holding what is
left of the stock down pipe using a 7/16” deep socket
wrench. The stock bank clamp will be used on the new
system.
7. Remove each piece of the stock exhaust system, in-
cluding the stock exhaust hangers. To make removal
of the hangers an easier process, it is recommended
that you use a silicone spray lubricant to spray each of
the rubber hangers that hold the stock exhaust.
Loosen Band Clamp
Cut on Flange
In these steps you will remove the stock exhaust system.
Cut Exhaust Behind Muffler
Cut Exhaust Directly in Front of Band Clamp
Cut on the Flange / Loosen Band Clamp
Cut Exhaust at Bottom of Down Pipe and
Top of Turbo Flange
Remove Hangers
7/16”