Rapid flow installation – Bully Dog 81052 Rapid Flow User Manual
Page 7
8
8
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81052
Hang the Hangers
2. Place all of the supplied Hangers into their appropriate
locations as shown in the above diagram.
3. Install the Down Pipe. You will use the stock band
clamp to secure the Down Pipe to
the turbo. Secure the Down Pipe by
tightening the stock band clamp with
a 7/16” deep socket.
4. Secure the Second Piece Down Pipe to the Down Pipe
using one of the supplied clamps. At this point, secure
the connection so that the piece will stay, but do not
tighten down until the entire exhaust is installed.
5. Reinstall the Catalytic Converter by connecting
it to the Second Piece Down Pipe. Remember to
install the included gasket, tighten and secure
with bolts.
6. Install the Adaptor Pipe onto the Catalytic Converter
and secure with a clamp.
Tighten Band Clamp
Second Piece Down Pipe
Catalytic Converter
Gasket
Reinstall Catalytic Converter
Catlytic Converter
Clamp
Adapter
Install Adapter
7/16”