Bully Dog 81052 Rapid Flow - Manual (Page 9)

10
10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81052
11. Once the entire exhaust system is installed, inspect the system to ensure that no part of the exhaust is in direct contact
with the chassis or body; adjustments may be necessary. Having any part of the exhaust system in direct contact with any
part of the body or chassis will cause the exhaust to rattle.
12. Return to each of the Clamps and tighten with a 9/16” wrench. Again, do not over tighten Clamps.
9/16”
ImPoRTaNT: Do not over-tighten clamps. Too much torque will result in deformation of the exhaust. For best results
when doing the installation, tighten the clamps enough to hold the exhaust pieces in place, but don’t tighten down until
the entire exhaust system is installed.
Tail Pipe Tip
Complete System Installed