Bully Dog 81052 Rapid Flow - Manual (Page 8)

9
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81052
7. Join together the Front Piece Tail Pipe and the Tail
Pipe Tip, secure with a Clamp.
8. Hang the combined pieces from Hangers C and D.
Ensure that the bend of the Front Piece Tail Pipe is di-
rectly over the axle. Secure the connection between
the two exhaust pieces with a clamp.
9. Install the Muffler by connecting it to the Front Piece
Tail Pipe and then tightening Hanger C.
10. At this point it is time to install the Straight Pipe. Keep in mind when you make your measurements that you
will need to leave an extra 3 inches of overlap when you cut the straight pipe. Do not cut the flared end.
SwITCH DIRECTIONS: THE NEXT STEPS wILL BE FROM THE BACk OF THE TRUCk
Hang Front Piece Tail Pipe from Hanger C
Hanger C
Hang Front Piece Tail Pipe from Hanger C
Front Piece Tail Pipe
Tail Pipe Tip
Hanger D
3”
Measure Straight Pipe
Measure Distance
Adapter
Muffler