Calculated Industries 4320 - Manual (Page 13)

P OCKET R EFERENCE G UIDE — 12
Fixed Fractional Mode
In the Fixed Mode ( Ç 9 ), fractional
results are displayed in the set fractional
value, not reduced. Entries of higher accu-
racy values will be rounded to the nearest
Fraction of the accuracy setting (for exam-
ple, for a Fraction level setting of 1/16, an
entry of
5 / 3 2 = will result in a dis-
play of 3/16).
ENTERING DIMENSIONS
Linear Dimensions
When entering Feet-Inch values, enter
dimensions from largest to smallest —
Feet before Inches, Inches before
Fractions. Enter Fractions by entering the
numerator (top), pressing
/ (Fraction Bar
key) and then the denominator (bottom).
Note: If a denominator is not entered, the frac-
tional setting value is used.
Examples of how linear dimensions are
entered:
DIMENSION KEYSTROKES
5 Yards 5 y
5 Feet 1-1/2 Inch 5 f 1 i 1 / 2
17.5 Meters 1 7 • 5 m
4320PRG-E-A 6/16/04 7:53 AM Page 12