Calculated Industries 4095-A Pocket Reference Guide - Manual (Page 27)

 (Material) mATl SIZE STEEl
 (Weight per Foot) PIPE SIZE 10.2528
lB Per fEET
 (Filled Weight/Foot) fIll SIZE 13.11634
lB Per fEET
 (Internal Area) AREA SIZE 6.605199
SQ INch
finding Pipe lengths
The components of rolling offset calculations
sometimes have different names in different
geographic regions and in different trades.
•
Roll – the horizontal component of a rolling
offset. May also be known as “offset”.
• offset – the vertical component of a rolling
offset. May also be known as “rise” or “set”.
• Bend – the bend angle, also known as “fitting
angle” or “angle of turn”.
Note: If an angle is not entered, or if the angle
is set to 0 degrees, the fitting angle is assumed
to be 90º.
Find the pipe Cutback when you are running
pipes through a 45º bend with a 10” offset.
KEySTRoKES DISPlAy

 0.

  /0 45.00 º

   ofST 10
INch

 cuT 4 1/8
INch
P
ocket
R
efeRence
G
uide
— 29
4095 Inside_Corrected.indd 27 4/27/2009 8:42:59 AM