Calculated Industries 4095-B User Guide - Manual (Page 33)

U
SER
’
S
G
UIDE — 33
6 and 1/4 inches, and outer arc length of 8 and 9/16 inches.
Note: To return the Welder’s Gap to the default 1/8”, press
  to reset your calculator back to default values.
Rolling Offset – Known Bend Angle
Find the center-to-center travel for a rolling pipe offset with a 4”
Roll and a 24” Offset using 45° factory-made long radius butt
weld elbows.
ADV
ANCE
LENGTH
OFFSE
T
ROLL
BEND
KEYSTROKE DISPLAY
  ALL
CLEArEd
1. Enter Offset:
   
OFST 24 INCH
2. Enter bend angle:
  
/_Ø 45.00º
3. Enter the Roll and calculate the pipe length:
  

LNTH 34-7/16 INCH
Continue pressing the Travel key to view all related values.