Calculated Industries 4095-B User Guide - Manual (Page 55)

U
SER
’
S
G
UIDE — 55
APPENDIX C –
Preference Settings
The Pipe Trades Pro has Preference Settings that allow you to
customize or set desired dimensional formats and calculations.
If you replace your batteries or perform a Full Reset* (press
 ,
hold down
 , and press 
), your calculator will return to the
following settings (in addition to those listed on the previous page):
*Depressing the Reset button located above the
 will also
perform a Full Reset. Asterisks below indicate default values.
Preference Options
1) Fractional Resolution – *1/16 (displays fractional values
to the nearest 16th of an Inch)
– 1/32
– 1/64
– 1/2
– 1/4
– 1/8
2) Area Display Format – *Standard (if units entered are
the same—e.g., Feet x Feet—the
answer will remain in this format
(Square Feet), but if units entered
are different — e.g., Inches
x Feet—area answer will be
displayed in Square Feet)
– Square Feet (area answers
always displayed in Square Feet,
regardless of unit entry — e.g.,
Inches x Inches = Square Feet)
– Square Inches (area answers
always displayed in Square Inches
— e.g., Feet x Feet = Square Inches)
– Square Meters (area answers
always displayed in Square Meters
— e.g., Feet x Feet = Square Meters)
(cont'd)