Entering dimensions linear dimensions – Calculated Industries 4094 User Guide User Manual
Page 11
![background image](/manuals/585130/11/background.png)
U
ser
’
s
G
Uide
— 9
(repeats options)
Std.
Third press of :
(Volume displays)
vol Std.
vol 0. cu fEET
vol 0. cu m
(repeats options)
vol Std.
Fourth press of :
(Meter Linear displays)
mETR 0.000 m
(floating point)
mETR floAt m
(repeats options)
mETR 0.000 m
Fifth press of :
(Decimal Degree displays)
DEG 0.00º
(floating point)
DEG floAt
(repeats options)
DEG 0.00º
Sixth press of :
(Fractional mode)
fRAc Std.
fRAc conSt.
(repeats options)
fRAc Std.
Seventh press of :
(Mathematical Operation)
mATh ordEr
mATh chA1n
(repeats options)
mATh ordEr
EnTERinG dimEnSionS
linear Dimensions
When entering feet-inch values, enter dimensions from largest
to smallest — feet before inches, inches before fractions. Enter
fractions by entering the numerator (top number), pressing
(Fraction Bar key) and then the denominator (bottom number).
Note: If a denominator is not entered, the fractional setting
value is used.