Calculated Industries 8015 - Manual (Page 29)

Entering Dimensions & Units
When entering feet-inch dimensional
values, you must enter the largest dimen-
sion first — feet before inches, inches
before fractions. To enter fractions of
an inch, enter the numerator (value
above the line), press
[/] (fraction bar
key) and then enter the denominator
(value below the line).
numerator 3
fraction bar —
denominator 16
For all other units of measurement, you
can only enter whole numbers or dec-
imal numbers. You cannot enter com-
binations of units (for example, you
cannot enter 12 meters 6 centimeters 4
millimeters).
U
SING THE
U LTRA M EASURE M ASTER
User’s Guide – 29
8015UG-E-B 7/31/03 3:43 PM Page 29