Tips, Notices – DJI Naza-M Lite User Manual
Page 17
©2014 DJI. All Rights Reserved.
17
Tips:
To move the slider is to adjust channel
－selected end-points.
For 3-position switch, you should assign: Position-1 to Manual Mode;
Position-2 to Atti. Mode; Position-3 to GPS Atti. Mode; or reverse
the assignment for Position-1 and Position-3.
For 2-positions switch, you can assign any two of these three control modes as you like.
If your transmitter supports Fail-Safe, follow the Fail-Safe setting procedure of your R/C TX. Then move the slider to
the range which makes Fail-Safe Mode turn blue, set Fail-Safe output of receiver to input port-U. If you switch off
your transmitter now, the U channel slide should move to Fail-Safe and turn the corresponding area to blue. Otherwise
please reset the fail-safe. MC has built-in auto level Fail-Safe function. That means when the communication between
MC and transmitter is disconnected, the outputs of all command sticks from MC will go to center point. If your
transmitter has only 4 channels, then MC will work in Atti. Mode by default without the Fail-Safe function.
Tips:
Please refer to your
RC manual
for the details of fail-safe setup.
With GPS, it is Enhanced Fail-Safe; without GPS, it is Auto Level Fail-Safe, and the aircraft will land.
Notices:
1.
Do NOT set the fail-safe position of throttle under 10% of endpoint.
2.
MC will not execute the Fail-Safe protection if you don’t set it properly. You can verify the Fail-Safe
settings by shutting down your transmitter, and then you can use the following method to check whether
MC is already in Fail-Safe mode.
3.
Check status bar at the bottom side of the software interface. If the Fail-Safe has been correctly set-up
the Control mode will change to Fail-Safe.
4.
Check the LED indicator. Read the appendix in this manual for details. LED will give fast yellow blinking
if in fail-safe mode.
5.
If your transmitter does not support Fail-Safe, the Fail-Safe function will not work when the communication
between MC and transmitter is disconnected.
6.
Do not use 4-channel Futaba transmitter with S-Bus receiver, otherwise MC will work in Fail-Safe mode.
7.
If users set GPS Atti. Mode in Control Mode Switch without connecting to GPS module, the M.C. will
switch GPS Atti. Mode into Atti. Mode automatically, and LED indicator will Blink yellow, that is if the 3-
poisition switch is the same as 2-position switch.
8.
Once the MC goes into the Fail-Safe Mode, and you are using the GPS, the aircraft will auto Stop the
Motors when landed; without GPS the aircraft the motors will not auto Stop when landed.
Tx
1
2
2 Position
Switch
Tx
1
2
3
3 Position
Switch