DJI Naza-M Lite - Manual (Page 34)

©2014 DJI. All Rights Reserved. 34
charging.
 Make sure your ESCs protection voltage is lower than 3.1V (1S), otherwise low voltage protection will not
work.
Acquire the line loss voltage by the above method, and then fill it in Loss. Then fill a reasonable warning voltage in
the No Load.
Notices:
When red LED starts to blink, you should land ASAP!
STEP4: Second Level Protection
1
Fill the warning voltage and the line loss voltage in No Load and Loss by the method introduced in previous
step.
2 When the second level protection is triggered, the LED warning will be on. Meanwhile the center point of
throttle stick will move up slowly to 90% of endpoint, you should land ASAP to prevent your multi-rotor from
crash or other harmful consequences!
3
When the center point is at 90% of endpoint, multi-rotor will still start to ascend slowly if you continue to pull
the throttle stick back, and the control of Pitch, Roll and Yaw are the same as before. Please land ASAP to
prevent your multi-rotor from crash or other harmful consequences!