Metrohm 902 Titrando - Manual (Page 23)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
902 Titrando
￭￭￭￭￭￭￭￭ 15
Figure 7 Connecting a dosing device
3.3.2 Connecting a stirrer or titration stand
You can use the following instruments:
￭ With built-in magnetic stirrer (stirring "from below"):
– 801 Stirrer
– 803 Ti Stand
￭ Without built-in magnetic stirrer (stirring "from above"):
– 804 Ti Stand with propeller stirrer 802 Stirrer
Connect a stirrer or a titration stand as follows:
1 Connecting the stirrer or titration stand
￭ Exit the control software.
￭ Connect the connection cable of the magnetic stirrer or of the
titration stand to one of the sockets marked with MSB on the
rear of the control instrument.
￭ 804 Ti Stand only: Connect the propeller stirrer to the stirrer con-
nector (socket with stirrer symbol) of the titration stand.
￭ Start the control software.