Metrohm 907 Titrando - Manual (Page 19)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
907 Titrando
￭￭￭￭￭￭￭￭ 11
3.2.1.1 Connecting a Touch Control
NOTE
The plug is protected against accidental disconnection of the cable by
means of a pull-out protection feature. If you wish to pull out the plug,
you will first need to pull back the outer plug sleeve marked with
arrows.
Connect the Touch Control as follows:
1 ￭ Insert the plug of the Touch Control connection cable into the
Controller socket.
Figure 4 Connecting the Touch Control
2 ￭ Connect the MSB devices (see Chapter 3.3, page 14).
￭ Connect the USB devices (see Chapter 3.4, page 18).
3 ￭ Connect the Titrando to the power supply.
4 ￭ Switch on the Touch Control.
The Touch Control power supply is supplied through the Titrando.
Automatic system tests are performed on both instruments at the
time of activation. The On LED on the front of the Titrando lights up
when the system test has been completed and the instrument is
ready for operation.