Bissell 18Z6 - Manual (Page 10)

To maintain maximum cleaning performance, the
following maintenance steps must be performed:
1. Empty the dirt container when the dirt
reaches the “Full” line on the front.
2. Check the pre-motor filter at least once a
month and clean and replace as needed.
3. Replace the HEPA media post-motor filter
every six months.
nOTE: More frequent filter cleaning may be
necessary if you are vacuuming new carpet,
fine dust, or have allergy concerns.
follow the instructions on the following pages
to perform these simple maintenance steps.
4. Allow parts to dry completely before
returning them back into the vacuum.
Empty dirt container
The dirt container needs to be emptied when the
dirt reaches the “full” line on the front of the
container.
1. Unplug cleaner from electrical outlet.
2. Slide the Lock ‘n Seal Lever to the “Unlock”
position.
3. Grasp handle and pull the dirt container
straight out to remove from vacuum.
4. Empty dirt into garbage container.
5. Put the dirt container back in the vacuum
and slide the lever to the “Lock” position.
The dirt container may be washed in warm
water with a mild detergent. Make sure it is
completely dry before replacing.
10
w w w . b i s s e l l . c a 1 - 8 0 0 - 2 6 3 - 2 5 3 5
M
aintenance and care
Full Line
Lock
Position Unlock
Position
Tip:
For maximum cleaning
performance, check and
clean or replace all filters
as suggested.
WARnInG:
To reduce the risk of electric
shock, turn Power Switch Off
and disconnect polarized plug
from electrical outlet before
performing maintenance or
troubleshooting checks.