Bissell 18Z6 - Manual (Page 5)

5
w w w . b i s s e l l . c a 1 - 8 0 0 - 2 6 3 - 2 5 3 5
H
ow to use this guide
A
ssembly
WARnInG:
Plastic film can be
dangerous. To avoid
danger of suffocation,
keep away from babies
and children.
This user’s guide has been designed to help you
get the utmost satisfaction from your BISSELL
vacuum. you’ll find assembly and operating
instructions, safety precautions, as well as
maintenance and troubleshooting instructions.
Please read this guide thoroughly before
assembling your vacuum cleaner.
Pay particular attention to the product diagram,
assembly instructions, and part names. Locate
and organize all parts before assembly. following
this user’s guide will greatly enhance your ability
to get the most performance from your BISSELL
vacuum for many years.
The only tool you’ll need to assemble your
vacuum cleaner is a Philips head screwdriver.
Attach handle to vacuum
1. Locate the vacuum handle and remove the
screw packet taped to the base of the handle.
2. Stand the vacuum upright and slide the base
of the handle firmly into the grooves at the top
of the vacuum body.
3. Check to be sure the handle is fitted to the
vacuum body. If there is a gap in front,
continue to push firmly until the handle is flush.
4. Insert the two screws from the screw packet
into the existing holes. Tighten securely with a
screwdriver.
Attach vacuum hose and tools
1. Position the Twist ‘n Snap Hose™ assembly
on the vacuum and line up the tabs on the
base of the hose with the corresponding
notches. Turn the Twist ‘n Snap Hose to the
right to lock into place.
2. Slide the end of the hose grip onto the hose
grip base. Place the hose into the hose clip.
nOTE: The powerfoot will not operate effectively
unless the hose is firmly attached to the base.
2.
4.
1.
2.