Bissell 18Z6 - Manual (Page 6)

16
w w w . b i s s e l l . c a 1 - 8 0 0 - 2 6 3 - 2 5 3 5
Attach vacuum hose and tools continued
3. Snap the telescoping extension wand,
crevice tool, and combination tool into
storage clips as shown.
4. The Pet TurboBrush snaps on to the holder
on the front of the handle.
Place the Pet TurboBrush in the holder by
hooking the bottom onto the tab and pushing
the top of the TurboBrush into place.
Power switch/brush switch
The power switch is located just below the handle
on the front of the detachable canister. Push the
rocker switch “On” (I) to vacuum, and “Off” (O)
when cleaning is complete.
The brush switch is located just below the
handle on the front of the detachable canister
next to the power switch. This switch turns the
rotating brush on and off. The brush switch
should be in the “On” (I) position for normal
carpet cleaning. you may want to turn the brush
switch “Off” (O) for bare floor cleaning or other
delicate surfaces.
note: your BISSELL Lift-Off MultiCyclonic Pet
vacuum is equipped with a special internal
switch that turns the rotating brush off
whenever the unit is in the Upright position.
Handle position
1. Upright- For storage and above floor clean-
ing with special tools.
2. normal Cleaning- Press handle release
pedal once. Use for most household floor
cleaning tasks.
A
ssembly
6
w w w . b i s s e l l . c a 1 - 8 0 0 - 2 6 3 - 2 5 3 5
Combination
Tool
Telescoping
Wand
Crevice Tool
Pet TurboBrush TM
CAUTIOn:
Before using your vacuum, make
sure that both filters (Pre-Motor
and Post-Motor) are in place. Do
not operate your vacuum without
these filters.
O
peration
Tip:
Your vacuum features a Quick-Release
Cord Wrap. To remove the Power Cord
quickly and easily, rotate the Upper
Cord Wrap towards floor, and slip Power
Cord from Upper and Cord Wraps..
Brush
Power
3.
1.
2.