Metrohm Liquid Handling Station - Manual (Page 16)

3.2 Installing the rinsing solution flow path
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
10 ￭￭￭￭￭￭￭￭
IC equipment: Liquid Handling Station
￭ Capillary cutter (6.2621.080)
1 Cutting the capillary to size
￭ Cut off a piece of approx. 60 cm from the long capillary using the
capillary cutter.
2 Mounting the capillary
￭ Tighten one end of the capillary to the pump tubing outlet using a
pressure screw (6.2744.010).
￭ Tighten the other end of the capillary to the rinsing unit inlet (2-4)
using a pressure screw (6.2744.010).
Completing the installation
1 Mounting the drainage tubing
Use the PVC tubing from the accessories for the Liquid Handling Sta-
tion as drainage tubing.
￭ Push one end of the PVC tubing over the waste connector (2-9)
of the rinsing unit.
￭ Guide the other end of the PVC tubing to the waste container.
2 Installing the peristaltic pump
￭ Insert the pump tubing in the tubing cartridge (see manual for
the Sample Processor).
￭ Insert the tubing cartridge in the cartridge holder (see manual for
the Sample Processor).
3 Placing the supply bottle
￭ Place the supply bottle next to the Sample Processor.