6 operation, 1 switching the instrument on and off, Switching the instrument on and off – Metrohm 900 Touch Control Short Instructions User Manual
Page 18

6.1 Switching the instrument on and off
■■■■■■■■■■■■■■■■■■■■■■
12
■■■■■■■■
6 Operation
6.1
Switching the instrument on and off
Switching on the instrument
CAUTION
Peripheral devices (e.g. printers) must be switched on before you switch
on the 900 Touch Control.
Proceed as follows:
1
■
Press the mains switch on the left-hand side of the rear panel of
the 900 Touch Control.
The 900 Touch Control and the control device are initialized and a
system test is carried out. This process takes some time.
■
If a buret unit is attached, then a request appears to carry out the
Prepare function:
All tubings and the cylinder are rinsed with the
Prepare function.
The preparing of the buret unit is described in the chapter Manual
control of the detailed manual.
■
Confirm the message with [OK].
The main dialog is displayed: