Metrohm 859 Titrotherm - Manual (Page 21)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
859 Titrotherm ￭￭￭￭￭￭￭￭ 13
3.3.1 Connecting a dosing device
Four dosing devices can be connected to the instrument (MSB 1 to MSB
4).
The types of dosing devices that are supported are:
￭ 700 Dosino
￭ 800 Dosino
￭ 805 Dosimat
Proceed as follows:
1 Connect the dosing device
￭ Exit the control software.
￭ Connect the connection cable to one of the sockets marked with
MSB on the rear of the 859 Titrotherm.
￭ Start the control software.
Figure 7 Connecting a dosing device
3.3.2 Connecting a stirrer or titration stand
You can use the magnetic stirrers 801 Stirrer or 803 Ti Stand (stirring
"from below") or the 804 Ti Stand with a propeller stirrer 802 Stirrer (stir-
ring "from above").
Connect a stirrer or a titration stand as follows:
1 Connect the stirrer or titration stand
￭ Exit the control software.
￭ Connect the connection cable of the magnetic stirrer or of the
titration stand to one of the sockets marked with MSB on the
rear of the 859 Titrotherm.