Metrohm TitrIC 6 - Manual

Application Bulletin 320 e
Installation Instructions of TitrIC 6
The TitrIC 6 System is used for the fully automatic analysis of water samples using direct measurement,
titration and ion chromatography. The lids of the air protected sample beakers are discovered with the
DIS-COVER function of the 815 and the following parameters are determined in a very short time:
temperature, conductivity, pH, acid capacity and, in parallel, the concentrations of the individual anions
and cations. Further Metrohm instruments can be incorporated in the existing system at any time and
used to determine additional parameters.
Analytical sequence
1. Conductivity is measured in the sample vessel on the sample processor.
2. First sample transfer to the 850 Professional IC for anions and cations.
3. The IC determinations are started automatically.
4. Second sample transfer to the external cell of the 815 Robotic USB Sample Processor XL.
5. Temperature, pH and acid capacity (p and m values) are determined.
The whole procedure is controlled by the TitrIC software: The user enters the sample position and
sample identification, MagIC Net and tiamo
TM
method, after which TitrIC transfers all the relevant
information to tiamo
TM
and MagIC Net. When the measurement has been concluded, TitrIC
automatically generates a joint report containing all results. This report can be exported as an Excel file.