Metrohm IC Net 2.1 - Manual (Page 81)

6.5 817 Bioscan
IC Net 2.1 73
Method data
Cell potential Definition of start and end potential for a
user-defined potential sweep, which is ap-
plied to the amperometric detector cell.
E1 Start potential for sweep.
Range:
-2 ... +2 V .
E2 End potential for sweep.
Range:
-2 ... +2 V .
Scan cycle Definition of scan cycle:
full double scan E1 ... E2 ... E1
half single scan E1 ... E2
Selection: full, half
Scan rate Definition of scan rate in mV/s.
Selection:
1, 2, 5, 10, 20, 50 mV/s
Oven Switching on/off column oven and setting
operating temperature.
Range:
15 ... 60 °C
Range Selection of measuring range:
pA 10 ... 5000 pA .
nA 0.1 ... 50 nA .
µA 0.01 ... 5 µA .
Full scale The full scale range (operating range) sets
the desired sensitivity for the analog output.
The possible values of the full scale range
depend on the preset measuring
Range .
Offset Offset of the zero point for the analog out-
put signal.
Selection:
-50 ... +50 % (in steps of 10 %)
Actual
E1, E2 Display of current start and end potentials
in V.
Scan cycle Display of current scan cycle mode.
Scan rate Display of current scan rate in mV/s.
Oven Display of current oven state.
Range Display of current measuring range.
Full scale Display of current full scale range.
Offset Display of current offset.
<Set> Send current parameters immediately to the
817 Bioscan. Parameters are not stored in
the system file (
*.smt ) as long as the file is
not saved.