Bowflex TreadClimber 3000 - Manual (Page 21)

Assembly Manual 17
Assembly
Figure 18-1
A/C inlet Power switch
Step 17: Final Inspection
17-1 Inspect your machine to ensure that all fasteners are tight
and components are properly assembled.
Be sure to record the machine serial number in the
Owner’s Manual.
Step 18: Attach the Power Cord
18-1 Make sure that the Power Switch is in the “Off” postition.
18-2 Carefully insert the power cord into the A/C inlet at the rear of
the base unit (See Figure 18-1).
NOTICE: Always plug cord into the base before plugging into the
wall outlet.
Note: The TreadClimber ® machine plugs into any standard,
grounded (three-prong) wall outlet.
NEVER remove the grounding prong from the power plug
and never use a two-prong adapter without a grounding
wire.
Do not use or put the machine into service
until the machine has been fully assembled
and inspected for correct performance in
accordance with the Owner’s Manual.