Bowflex TreadClimber 3000 - Manual (Page 22)

18 Assembly Manual
Assembly
Figure 19A
Main Power Switch “On”
Speed Sensor Verification (TC1000 only)
19-1 Insert yellow safety key, plug the power cord into a wall
outlet, and turn on the red Power Switch at the rear of
machine. (See Figure 19A.)
19-2 Standing to the left of the machine, activate the Start/
Stop switch. Belts should begin moving within a few
seconds.
19-3 Allow belts to continue to turn for at least 15 seconds
(elapsed time will be displayed on Console). If belts stop,
note any error codes displayed on Console and turn
power off at rear of machine. Contact customer service
for assistance immediately at 1-800-605-3369.
19-4 Push FASTER button until SPEED display reads 1.5. Verify
that belt speed increases and then holds constant at new
speed.
19-5 Remove safety key. Belts should slow to a complete stop.
19-6 Replace safety key. Belts should remain stopped.
19-7 Push RESET button on Console. Your TC1000 is now
ready to use. Review Owner’s Manual for operating
instructions.
NOTICE: If your TreadClimber ® machine does not operate
correctly as described in the above steps, do not use
machine. Contact Customer Service for assistance
immediately at
1-800-605-3369 .
SAFETY KEY
Figure 19B
TC1000 Faster Button
Step 19: Verify (TC1000 only) or Calibrate (TC3000 & TC5000)
Do not use the machine for exercise purposes without completing Calibration (TC3000/5000)
or Speed Sensor Verification (TC1000).
It is important to calibrate (TC3000/5000) or verify speed sensor operation (TC1000) after a
power outage or after any electrical repair or replacement. Failure to follow this procedure
prior to use could result in machine failure and could cause injury.
Do not stand on the Walking Belts during calibration or speed sensor verification. During the
entire process, stand on the side foot support platforms or beside the machine.