Watts WP8S - Manual

Brass CrimpRing ™
& CinchClamp ™
Couplings
Brass CrimpRing ™ & CinchClamp ™ Couplings and Coupling
Kits are used for making WaterPEX ® repairs in the field, contin-
uing a run as well as transitioning from polybutylene pipe to
WaterPEX
® tubing.
Specifications
System shall be plumbed using Watts WaterPEX ® cross-linked
polyethylene pipe, and all joints shall be made using Watts
brass CrimpRing
™ and/or polyalloy CrimpRing ™ fittings using
either the Watts copper CrimpRing ™ or stainless steel
CinchClamp ™ * crimping methods as outlined in the Watts
WaterPEX ® Installation Guidelines.
Installation Note
Brass Couplings must be installed in accordance with all Watts
WaterPEX
® installation procedures, including information
provided in WaterPEX ® installation manual and guidelines.
Approvals
• Manufactured in accordance with American Society for
Testing and Materials (ASTM) F-877 and F-1807
• Listed by the National Sanitation Foundation to NSF
Standards 14 and 61 for use in potable water systems
• Listed by NSF to be in compliant to the Uniform Plumbing
Code
• Labeled B137.5 which indicates that it is compliant to the
CSA Standards B137.5
For Residential and Commercial Applications
ES-WP-BrassCouplings
Job Name ––––––––––––––––––––––––––––––––––––––––––– Contractor ––––––––––––––––––––––––––––––––––––––––––––
Job Location ––––––––––––––––––––––––––––––––––––––––– Approval –––––––––––––––––––––––––––––––––––––––––––––
Engineer ––––––––––––––––––––––––––––––––––––––––––––– Contractor’s P.O. No. –––––––––––––––––––––––––––––––––––
Approval ––––––––––––––––––––––––––––––––––––––––––––– Representative ––––––––––––––––––––––––––––––––––––––––
WP15
PEX x PEX CrimpRing ™ Coupling
WP8S
PEX x PEX CinchClamp ™ Coupling Kit
(Each kit contains 4 CinchClamps ™ and 2 brass couplings)
WP16
PEX x PEX CrimpRing ™ Coupling Kit
(Each kit contains 4 copper CrimpRings ™ and 2 brass couplings)
WP17
PEX x PB Trasition Coupling Kit
(Each kit contains 2 copper CrimpRings ™ and one PB coupling)
* Note: Watts WaterPEX CinchClamp ™ fittings should not be
used with wrot copper PEX fittings.
W a r n i n g !
If connections must be made in temperatures below 30°F,
caution must be taken to allow the WaterPEX to form a proper
seal against the barb. Apply the connection slowly to ensure
the PEX material conforms to the barb.
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
ES-WP-LFBrassCouplings.qxd 3/10/09 3:01 PM Page 1